GOOD - Continuity test pathway - #1 Pin to BLACK Wire - #7.

GOOD - Check pathway (check continuity from pin #6 to end of RED power wire, check Snap Disk(s) continuity, check Flow Switch, check pin #7 to the end of WHITE wire.

Check for pinched vacuum hose or blocked hose on flow switch.

Check continuity from #3 pin to the fuse lead.

NO START UP MODE Power Up Unit & Push Start Button

- From pin #7 to the end of the white wire.

from - pin #5 - to the end of the brown wire.

With the appliance ON/OFF switch off, unplug and replug the power cordĬonvection Fan or Exhaust Blower Comes On Pellet Troubleshooting Flow Chart Pellet Troubleshooting Flow Chart YES YES Enough coals in the burnpot to ignite new pellets

Thermostat Eventually Closes Calling For Heat Power Outage In automatic operation (Wall Thermostat or Remote Control) Pellets Pile Up Enough coals in the burnpot to ignite new pellets.Power Outage Pellet Appliance Stops Power Comes On Power Outage In manual or Remote Control (ON/OFF) operation

LOW ON 3 Seconds HEAT OUTPUT OFF 12-15 Seconds HIGH ON 3 Seconds HEAT OUTPUT OFF 2 Seconds MEDIUM ON 3 Seconds HEAT OUTPUT OFF 6-9 Seconds The auger feed light on the control board will be lit for the.In the box below you will see the ON/OFF rates:.feed, we control the on and off time of the auger motor.The feed rate of the pellets is determined by the ON/OFF.Convection Blower and Exhaust Blower Run.HEAT NEEDS ARE SATISFIED Manual - OFF Automatic Thermostat - OFF Remote - OFF Operating at Control Board Heat Output Setting.Exhaust Blower and Auger Feed Rate Mode.Convection Blower - ON at Control Board Fan Setting.Pellets Are Burning and the System Snap Disk Closes (Should happen in 6-7 minutes)

following page provides a detailed flow chart of what happens.

Below are the steps our pellet appliances go through.

Pellet appliance operation sequence is important to understand.

Appliance Operation Principles Pellet Appliance Operation Sequence

Astoria bay pellet stove